Ubuntu 17.04
Sponsored Link

Networking
2017/04/13
[1] Change to static IP addres if you use Ubuntu as a server.
[ens3] is different on each environment, replace it to your own one.
root@dlp:~#
vi /etc/network/interfaces 
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).

source /etc/network/interfaces.d/*

# The loopback network interface
auto lo
iface lo inet loopback

# The primary network interface
auto ens3
# comment out

#
iface ens3 inet dhcp
# add these lines

iface ens3 inet static
# IP address

address 10.0.0.30
# network address

network 10.0.0.0
# subnet mask

netmask 255.255.255.0
# broadcast address

broadcast 10.0.0.255
# default gateway

gateway 10.0.0.1
# name server

dns-nameservers 10.0.0.10
# reboot once

root@dlp:~#
reboot

[2] Disable IPv6 if not needed.
root@dlp:~#
echo "net.ipv6.conf.all.disable_ipv6 = 1" >> /etc/sysctl.conf

root@dlp:~#
sysctl -p
root@dlp:~#
ip addr 

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
       valid_lft forever preferred_lft forever
2: ens3: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP group default qlen 1000
    link/ether 52:54:00:99:9b:07 brd ff:ff:ff:ff:ff:ff
    inet 10.0.0.30/24 brd 10.0.0.255 scope global ens3
       valid_lft forever preferred_lft forever
 
Tweet